569-13-56750 5691356750 High Quality Start Switch Ignition Switch Forklift Truck HD465-7E0 HD605-7E1

1. Quick Details of  seal 569-13-56750 :

2. 569-13-56750  parts on group :

3. 569-13-56750  picture:

4. Service part number :

 
5. FAQ

Q: How do I install this kit correctly?

A: Start by cleaning the housing bore, shaft, and all sealing surfaces thoroughly to remove dirt, old sealant, or debris. Inspect the shaft for wear, scoring, or corrosion, as even minor damage can cause the new seal to leak. When installing the oil seal, use a proper driver to press it evenly into the housing until it seats fully, taking care not to damage the sealing lip. For the shims, select the correct thickness based on the equipment’s service manual specifications, then place them in the proper location to achieve the required bearing clearance. Reassemble the components according to the manufacturer’s instructions, then check the shaft end-play or preload to ensure it is within the correct range.

Q: What common mistakes lead to early failure?

A: Poor cleaning leaves debris that damages the seal lip or prevents the shims from seating flat. Installing the oil seal unevenly or with the wrong tool can damage the lip, causing leaks immediately. Using the wrong thickness shim results in incorrect bearing clearance, leading to excessive wear or overheating. Installing the seal backwards means the lip won’t hold lubricant in properly.

Q: How long can these parts last if installed correctly?

A: With proper installation, clean lubricant, and correct clearance settings, the oil seal can last 5,000–10,000 operating hours, while the metal shims will typically last the life of the assembly unless they are damaged during service.

Q: Can I reuse the old shims?

A: While the shims themselves don’t wear out, it’s best to use new ones if possible, especially if they are bent, scratched, or have been deformed during disassembly. Reusing old shims can lead to incorrect clearances if they are damaged, so always inspect them carefully before reuse. The oil seal, however, should always be replaced with a new one during service.

6. Exhibition and Wearhous

Oil seals,Hydraulic Seals, Cylinders Seal Kits, And More